The main operation process of using China hydraulic jacking equipment for storage technology for construction is: first prefabricate the materials, and then use the jacking technology to construct and install the prefabricated sections. However, some problems are often encountered during the prefabrication process. Correctly analyzing these problems and finding corresponding solutions are important for improving construction technology and construction quality. The first is the selection of the prefabrication site. It is necessary to comprehensively consider the length of the prefabrication site and the prefabrication express, which is generally three times the stage, so as to determine the convenience and feasibility of the transportation and construction process. At the same time, a push transition section should also be set to ensure the smooth progress of the hydraulic jacking device. For the intermediate support in the transition section of the jacking, do a good job, and try to ensure that it presents a linear relationship in the horizontal direction. For the situation where the linear relationship cannot be determined, comprehensive consideration should be given to the specific situation during calculation and construction.

After the installation of the china hydraulic jacking equipment for storage system is completed, debug it according to the following steps:

1. Check whether the oil pipe connection between the pump station and the main cylinder of the hydraulic lifting device and the anchorage cylinder is correct;

2. Check whether the joints of individual valves or hard pipes on the pumping station are loose, and check whether the pressure regulating spring of the overflow valve is fully relaxed;

3. Check whether the cable connection between the starting cabinet of the pump station and the hydraulic lifting device is correct;

China hydraulic jacking equipment for storage system power supply, check the hydraulic pump main shaft rotation direction is correct.